Setδslipresp; Setδupdate; Setδresponse_Table - NEC MG-SIP Configuration Manual

•
When enable (=1) is selected:
7.5.3.43 SETΔSLIPRESP
This command is used to determine a SLIP response code. To make this assignment effective, it is required to
execute the "REBOOT" command to restart the MG-SIP16.
7.5.3.44 SETΔUPDATE
This command is used to enable/disable the use of update method. Pressing the Enter key can skip the item. In this
case, default values are assigned automatically. To make this assignment effective, it is required to execute the
"REBOOT" command to restart the MG-SIP16.
Note: Assign this command adjusting to the specification on SIP network.
7.5.3.45 SETΔRESPONSE_TABLE
This command is used to set response table. Pressing the Enter key can skip the item. To make this assignment
effective, it is required to execute the "REBOOT" command to restart the MG-SIP16.
MG-SIP Page 50 of 75 5/8/2009