Table of Contents
Advertisement
7. MG-SIP Startup and Programming
7.1 Maintenance Console Settings
Use a serial connection client such as Hyperterminal to connect MG-SIP16 on a software basis. Be sure to
connect RS-232C cable (straight cable) between MG-SIP16 and the Maintenance Console (PC) when
initially setting up MG-SIP16.
STEP 1: Open a communication software Hyper Terminal on the Maintenance Console, and set up the
connection with MG-SIP16.
(1) Startup Windows on the Maintenance Console.
(2) Click Start, point to Programs
Terminal icon.
(3) Communication setting dialog box appears. Enter the name, icon, connection type, and port settings.
There is no specific note in assigning the name and icon. Select the connection type
Note:
COM1 (depending on the PC). Port settings should be specified as follows:
STEP 2: Power ON the switch on the rear panel of MG-SIP16. Linux installed in MG-SIP16 is activated.
STEP 3: The following message is displayed on the Maintenance Console screen. NOTE 1
MG-SIP
Communications, and then click Hyper
Accessories
Page 17 of 75
5/8/2009
Hide quick links:
Advertisement
Table of Contents
