USB Connector board
NOTE:
The connector board spare part kit includes the connector board cable.
Description
Connector board with cable
Before removing the connector board, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
Optical drive (see
b.
Bottom cover (see
Remove the connector board:
1.
Disconnect the connector board cable (1).
2.
Disconnect the power button board cable (2).
3.
Remove the two 2.5×3.7 screws (3) that secure the connector board to the keyboard/top cover.
4.
Lift connector board away from computer (4).
Reverse this procedure to install the connector board.
Battery on page
31), and then remove the following components:
DVD±RW Double-Layer SuperMulti Drive on page
Bottom cover on page
34).
Spare part number
806750-001
32).
Component replacement procedures
43