Usb/Power Connector Board - HP dv6000 Maintenance And Service Manual

USB/power connector board

Description
USB/power connector board (includes USB/power connector board cable)
Before removing the USB/power connector board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Optical drive (see
b.
Switch cover (see
c.
Keyboard (see
d.
Speaker assembly (see
e.
Display assembly (see
f.
Top cover (see
g.
Remove the USB/power connector board:
Remove the two Phillips PM2.5×4.0 screws (1) that secure the USB/power connector board to the
1.
computer.
Release the USB/power connector board (2) as far as the USB/power connector board cable will
2.
allow.
ENWW
Battery on page 40).
Hard drive on page 45)
Optical drive on page
Switch cover on page
Keyboard on page 58)
Speaker assembly on page
Display assembly on page
Top cover on page 66)
52)
54)
56)
61)
Component replacement procedures
Spare part number
449454-001
73