Tyre Pressure Monitoring - Skoda CITIGO Owner's Manual

Disable / Enable

Read and observe and
The function is automatically activated each time the ignition is switched on.
Deactivating/activating
›
Press the button » Fig. 99.
If the system is turned off and the vehicle is moving at a speed of about 5-30
km/h, the warning light  lights up in the instrument cluster display.
If the system is activated, the warning light  lights up in the instrument
cluster display for a few seconds.
WARNING
For safety reasons, deactivate the system in the following situations.
When the vehicle is being towed away.
■
When the vehicle is driven though an automatic car wash.
■
If the laser sensor is damaged or faulty.
■
When the vehicle is on a rolling test bench.
■
When the windscreen is damaged in the region of the laser sensor.
■
For example, if the charge extends to the roof rack over the front edge of
■
the roof.

Tyre pressure monitoring


Introduction
This chapter contains information on the following subjects:
Storing the tyre pressure values.
Fig. 99
Button for the City Safe Drive
system
on page 81 first.
The tyre pressure monitoring function (hereinafter referred to as: the system)
monitors the tyre pressure while driving.
If the tyre inflation pressure changes, the warning light
strument cluster and an audible signal is
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
WARNING
The general information relating to the use of assistance systems must
■
be observed » page 77,
Having the correct tyre inflation pressure is always the driver's responsi-
■
bility. Tyre pressure should be checked regularly
The system cannot warn in case of very rapid tyre inflation pressure loss,
■
e.g. in case of sudden tyre damage.
Storing the tyre pressure values.

Read and observe
Procedure for storing the tyre pressure values
›
Inflate all the tyres to the specified pressure.
›
Switch on the ignition.
›
Press down  » Fig. 100
The warning light lights up in the instrument cluster.

An acoustic signal and the control indicator provide information about the
storage of the tyre pressure values.
›
Release  the button.
83

heard» page 35,

in section Introduction.
» page 104.
Fig. 100
Key for storing the pressure val-
ues
on page 83 first.
on the button.
Assist systems
lights up in the in-
Tyre pressure.

83