Instruments and warning lights
Instrument cluster
Introduction
Fig. 16 Instrument cluster - Version 1
Fig. 17 Instrument cluster - Version 2
This chapter contains information on the following subjects:
Rev counter
Fuel gauge
Trip counter
28
Using the system
Service interval display
Recommended gear
Speedometer
1
Display:
2
▶
With counter for distance driven
▶
With service interval display
▶
With multifunction display
▶
With outside temperature display
▶
With fuel gauge (only in the instrument cluster - variant 2)
page 29 - .
Button:
3
▶
Switch between the counter for the distance driven (trip) and the odom-
eter
» page 29
▶
Reset counter for distance travelled (trip)
▶
Set the time
» page 32
Fuel gauge
» page 29
4
Engine revolutions counter
5
Time adjust button
» page 32
6
The instruments are also illuminated when the side light or low beam light is
switched on.
Note
Appears in the display then the system indicates that the ignition is
switched on.
Rev counter
The tachometer
» Fig. 17
5
nute.
The beginning of the red scale range of the tachometer indicates the maxi-
mum permitted engine speed of a driven-in and operating warm engine.
You should shift into the next highest gear before the red scale of the revolu-
tion counter is reached, or select mode D on the automatic gearbox.
The gear recommendation is important to note in order to maintain the opti-
mum engine speed
» page
28
29
29
» page 29
» page 30
» page 30
» page 29
» page 28
on page 28 shows the actual engine speed per mi-
30.
30
30
» Fig. 18
on