The system stores data from the two memories described below, which are
then displayed at position
» Fig.
A
"1" - Single-trip memory
Drive data is stored from when the ignition is switched on to when it is switch-
ed off. If the trip is continued within 2 hours after switching off the ignition,
new data will also flow into the calculation of the current driving information.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
"2" - Long-term memory
The memory gathers driving information from any number of individual jour-
neys up to a total of 19 hours and 59 minutes driving or 1,999 kilometres driv-
en.
The indicator is automatically set back to zero if one of these two values is ex-
ceeded.
›
To select the preferred memory bank choose the desired specification of the
multi-function display and select by repeatedly confirming the preferred
memory bank.
To reset the memory bank see
» page
The following drive data is stored in different memory banks.
▶
Average fuel consumption.
▶
Distance driven.
▶
Average speed.
▶
Driving time.
Note
Disconnecting the vehicle battery will delete all memory data.
32
Using the system
23.
30, Operation.
Buttons in the instrument clus-
ter - variant 1
›
Switch on the ignition.
›
Press down button
until» Fig.
A
›
The hour is set by repeatedly pressing button
›
Switch to the minutes by pressing button
›
The minutes are set by repeatedly pressing button
›
Confirm the value entered by pressing button
seconds. The setting is saved automatically (the value stops flashing).
Warning lights
Introduction
This chapter contains information on the following subjects:
The warning lights in the instrument cluster indicate the status of certain
functions or the presence of faults.
24the hour flashes in the display.
.
B
.
A
.
B
A
33
33
33
33
33
34
34
34
35
35
35
36
36
36
36
36
36
37
37
37
37
37
37