Skoda CITIGO Owner's Manual page 102

The coolant helps to keep the engine temperature down, and consists of wa-
ter and coolant additive (with additives that protect the cooling system against
corrosion and prevent furring).
The proportion of coolant additive in the coolant must be 40 to 60 %.
The correct mix of water and coolant additive should be checked and if neces-
sary corrected by a specialist garage.
WARNING
The following instructions must be followed at all times when working on
■
the engine compartment » page
Never open the end cover of the coolant expansion reservoir while the
■
engine is still warm. The cooling system is pressurised - risk of scalding or
injury from splashes of coolant!
To protect against the coolant splashing, cover the cap with a cloth when
■
opening.
Coolant and coolant fumes are harmful - avoid contact with the coolant. If
■
the coolant comes into contact with the eye or skin, wash the affected area
with plenty of water for several minutes, and where appropriate seek medi-
cal help.
CAUTION
Do not cover the radiator and install any parts (e.g auxiliary lights.) in front of
the air intakes - risk of the engine overheating.
Checking and refilling
100
General Maintenance
96.
Fig. 110
Coolant expansion reservoir

Read and observe and
Check and refill coolant under the following conditions.
The vehicle is on a horizontal surface.

The engine is not warm (if the engine is warm the result of the check may

be wrong).
The engine is turned off.

Check the coolant level - The coolant level must lie between the marks
» Fig. 110. If the coolant level is below the mark
B
Refilling
The reservoir must always contain a small amount of coolant
›
Place a cloth over the cap of the coolant expansion tank and unscrew the
cap carefully.
›
Always top up using coolant of the correct specification.
›
Turn the cap until it clicks into place.
The specification for the coolant is shown in the coolant expansion reservoir
» Fig. 110.
If the specified coolant is not available, then refilling only with distilled or dem-
ineralised water, and get a specialist garage to correct the water-coolant addi-
tive mix as soon as possible.
CAUTION
If the expansion tank is empty, do not top up with coolant. The system could
■
aerate - risk of engine damage!

gine and seek assistance from a specialist garage.
Do not fill the coolant above the mark
■
heated, be expelled from the cooling system - risk of damage to the engine
parts.
If it is not possible to add coolant,
■
engine and seek assistance from a specialist garage.
A coolant additive which does not correspond to the correct specification can
■
reduce the anti-corrosion effect of the cooling system - risk of damage to the
cooling system and the engine.
If non-distilled (non-demineralised) water has been used to top up, the cool-
■
ant should be replaced by a specialist garage - risk of engine damage.
A loss of coolant indicates leaks in the cooling system - risk of engine dam-
■
age. Top up with coolant and then seek assistance from a specialist garage.
on page 100 first.
, top up with coolant.
B
»
Do not drive the vehicle! Switch off the en-
» Fig. 110. The coolant could, when
A
do not continue driving! Switch off the

and
A
.
