Turn Signal System; Cruise Control System; Main Beam; Rear Seat Belt Warning Light - Skoda CITIGO Owner's Manual

Turn signal system

 

Read and observe on page 33 first.
flashes – the left turn signal is turned on.

flashes – the right turn signal is turned on.

If there is a fault in the turn signal system, the warning light flashes at twice
its normal rate.
When the hazard warning light system is switched on, this will cause all of the
turn signal lights as well as both warning lights to flash.

Cruise control system



Read and observe on page 33 first.
lights up – the vehicle speed is regulated by the cruise control system.


Main beam



Read and observe on page 33 first.
lights up – the main beam or the headlight flasher is switched on.

/ Rear seat belt warning light

Read and observe on page 33 first.
 lights up – a rear seat belt is not fastened.
 lights up – a rear seat belt is fastened.
When the seat belt is fastened/unfastened, the particular light lights up briefly
and indicates the current belt status!
 City Safe Drive

Read and observe on page 33 first.
 flashes quickly - the City Safe Drivesystem is braking the vehicle automati-
cally.
 flashes slowly - the system is not available or there is a system malfunction.
If the system is turned off and the vehicle is moving at a speed of about 5-30
km/h, the warning light  lights up in the instrument cluster display.
If the system is activated again, the warning light   lights up in the instru-
ment cluster display for about 5 s.
Further information » page

81, City Safe Drive.

 /  START-STOP

Read and observe on page 33 first.
 lights up - the START-STOPsystem is active.
 lights up - the START-STOPsystem is active, but the automatic engine cut-
off is not possible.
 flashes - the START-STOPsystem is not available.
Further information » page 70, START-STOPsystem.
Instruments and warning lights
37