›
Take out the cover in the direction of arrow
Inserting
›
Position the fixtures
on the cover over the studs
D
›
Press down on both sides on the top of the cover in the area of the studs
The fixtures
must lock into place in the studs
D
gage compartment.
›
On both sides of the boot lid unhook the straps
WARNING
Do not place any objects on the cover during the trip - risk of injury if
■
braking suddenly or colliding!
Never ride with the cover up - risk of damage to the cover.
■
Variable loading floor
Fig. 77 Variable loading floor in the raised position: raise / raised
Fig. 78 Variable loading floor: lower / lowered
.
2
» Fig.
76.
C
.
C
on both sides of the lug-
C
.
A
Read and observe
and
›
To raise the loading floor, grasp handle
direction of arrow
» Fig.
77.
1
›
To lower it, lift the loading floor, push it into the grooves in the direction of
arrow
insert and lay it on the luggage compartment floor in direction of
2
arrow
.
3
Class N1 vehicles
Read and observe
and
In class N1 vehicles that are not fitted with a protective grille, a lashing set that
complies with the EN 12195 standard (1-4) must be used for fastening the load.
For safe vehicle operation, the proper functioning of the electrical installation
is essential. It is important to ensure that it is not damaged in adaptation as
well as the loading and unloading of the cargo space.
Transportation on the roof rack
Fig. 79 Attachment points - 3-door
on page 61 first.
and raise as far as the stop in the
A
on page 61 first.
Transport of cargo
63