Skoda CITIGO Owner's Manual page 112

Anti-theft wheel bolts
The anti-theft wheel bolts protect the wheels from theft. This can only be
» Fig. 120 loosened / tightenedwith attachment
›
Insert the attachment » Fig. 120
B
bolt .
A
›
Insert the key as far as it will go onto attachment
wheel bolt.
›
Remove the attachment.
The attachment for the anti-theft wheel bolts must always be kept in the ve-
hicle in case of a possible wheel change.
For wheel trims supplied ex-factory or from ŠKODA Original Accessories, the
anti-theft wheel bolt should be installed in the position marked on the back of
the wheel trim» page 109.
Note
The attachment and the anti-theft wheel bolts are provided with a code num-
ber. A replacement attachment can be ordered from ŠKODA Genuine Accesso-
ries using this.
110
Do-it-yourself
Fig. 120
Anti-theft wheel bolt and attach-
ment
.
B
as far as it will go on the anti-theft wheel
and loosen / tighten the
B
Loosening/tightening wheel bolts
›
Insert the wheel wrench onto the wheel bolt to the stop. Use the associated
attachment for the anti-theft wheel bolts
›
To loosen the screws, grasp the key end and turn the screw about one turn
rotation in the direction of the arrow
›
Totighten the screws grasp the key end and turn the screw about against
the direction of the arrow » Fig.
WARNING
If it proves difficult to undo the bolts, carefully apply pressure to the end of
the wrench with your foot. Keep hold of the vehicle when doing so, and
make sure you keep your footing - danger of injury.
Raising the vehicle
Fig. 121
Loosening the wheel bolts
» Fig. 120 on page 110.
» Fig. 121.
121, until it is tight.
Fig. 122
Jacking points for the jack
