General Characteristics - Cembre RDS-14P Operation And Maintenance Manual

3.1) General Characteristics:

– Application range: cutting rail with suitable abrasive cutting disc.
– Dimensions: ................................................................................................... refer to Fig. 2 and 3, page 39
– Weight (without support arm or cutting disc): .......................................................19 kg (41.8 lbs)
– Combustion engine:
– type: ..................................................................................................Husqvarna, 2 stroke, single-cylinder,
– displacement: ............................................................................................................... 119 cc (7.26 cu.inch)
– bore/stroke: ................................................................................................ 60 mm (2.36") / 42 mm (1.65")
– power: ........................................................................................................................................5.8 kW (7.8 HP)
– n° of revs idling: ..................................................................................min. 2500 - max.9750 ± 250 RPM
– carburettor: ..................................................................................................................................Walbro WG 9
– spark plug: ............................................................... CHAMPION RCJ6Y, NGK BPMR7A or equivalents
– fuel: ...............................................................................................................................................petrol mixture
– tank capacity: .........................................................................................................1.25 litres (2.65 US Pint)
– clutch: ........................................................................................centrifugal with automatic intervention
– start: ................................................................................................... by rope pull with automatic rewind
– Cutting group:
– n° of revs of drive shaft: ................................................................................................................4,700 RPM
– drive shaft diameter (RDS-14P): ............................................................................................ 25.4 mm (1")
– drive shaft diameter (RDS-14P.78): ................................................................................... 22.2 mm (7/8")
– max. diameter of suitable cutting disc: .............................................................................406 mm (16")
– max. cutting depth: .................................................................................................................140 mm (5.5")
– Acoustic noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
– The maximum value of the weighted acoustic displacement
pressure C at the work place L
– The acoustic power level emitted by the machine
L is equal to ..................................................................................................................................... 116 dB (A)
WA
– Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and
UNI EN 28662 part 1
than those normally found, certify that the weighted root mean square in frequency of
the acceleration the upper limbs are exposed is 11.42 m/sec
is equal to ...........................................................................................105.5 dB (A)
pA
is equal to ....................................................................121.3 dB (C)
pCPeak
st
Standards, and under operating conditions much more severe
air cooled, electronic start, 5-stage air fi lter
2 max.
6