Table of Contents
Advertisement
The figure shows the
correct positioning of
the rail saw supported by
the arm on the two sides
of the rail, in stationary
position.
6.4) Mounting/dismounting the rail saw on the automatic support arm
Before mounting the rail saw on the support arm:
Check the gear (8) is in the downward position as described in § 6.3.1.
Make sure clamp (6) is fi rmly locked as described in § 6.1 and levers (17 and 18) are
completely inserted.
1- Mount the rail saw on the support arm, pushing
it up to the end, and the three elements a (anti-rotation
pin) b (interface pin) c (motion transmission gear) match
with the slots on the two sides of the rail saw.
2- Push and rotate the handle (13) tightening it fully.
To dismount the rail saw, completely loosen the handle (13) and remove
it from the arm.
1
8
a
b
c
2
13
18
17
6
20
Advertisement
Table of Contents
