Mounting The Cutting Disc - Cembre RDS-14P Operation And Maintenance Manual

4.3) Mounting the cutting disc

WARNINGS:
– This operation must be performed with the engine switched off .
– Before using a cutting disc, always verify its compatibility with the rail saw
and observe the rules set out in § 3.4.
– Verify that the hub of the disc is perfectly suitable for the shaft.
– Always mount the disc complete with pressure plate.
– In order to avoid an overtightening of the screw (12), start the engine only when
the abrasive cutting disc is mounted.
– With the 13 mm multifunction spanner supplied, unscrew the locking screws (12) and
retrieve the pressure plate (S).
– Mount the disc on the shaft inside the safety guard so that it rests on the central stop.
– Mount the pressure plate and lock all the screws (12)
tightening with a 20-25 Nm.
During the tightening phase
counteract the movement
of the disc
with one hand.
NOTE: with the RDS-14P.78
type rail saw, check that the
disc hub is suited to the 7/8"
shaft.
NEVER use cutting discs with
a 1" hub on a rail saw with a
shaft of 7/8".
11
min. 3 m (10ft)
S
20-25 Nm
non-spill fuel
container
1
2
12