Cembre RDS-14P Operation And Maintenance Manual page 9

3.4) Abrasive cutting discs
For maximum performance, use the rail saw in conjunction with the high quality C-Rex range
Cembre discs listed below, in compliance with the requirements of the standard EN 12413 for
bonded abrasives:
DISC
TYPE
CRDL4387 355x3.8x22.2 (14"x5/32"x7/8")
CRDL4381 355x3.8x25.4 (14"x5/32"x1")
CRDL6407 406x4.0x22.2 (16"x5/32"x7/8")
CRDL6401 406x4.0x25.4 (16"x5/32"x1")
– The RPM shown on the abrasive cutting disc label must be equal to or higher than that
produced by the rail saw.
– Never use the rail saw for grinding operations on the side surface of the disc, as it may break
and cause serious injury.
– The cutting discs must only be used for cutting suitable materials.
– During transportation and storage of the rail saw, always remove the cutting disc and lay
it on a fl at surface in a dry place protected from frost and moisture.
– Always tighten the fi xing screw of the cutting disc with a 20-25 Nm torque, to prevent the
disc from loosening.
– Worn or broken discs must be disposed of in compliance with local statutory requirements.
Always, use good quality cutting discs with a diameter
of 355 mm (14") or 406 mm (16") marked "RAIL" specifi c for
rail cutting.
The cutting disc may only be replaced when the engine
is switched off !
Never use a cutting discs designed for a lower rpm than
that of the rail saw.
Never use a cutting disc beyond its expiration date, if
indicated.
Before using a cutting disc always check it is completely
free from damage.
A simple test for verifying the integrity of a cutting disc is to hold
it in the air and gently tap it with a screwdriver or a piece of wood;
an intact disc will produce a low drumming tone.
9
Dimensions
diameter x thickness x hub
mm (inch)
Peripheral
speed
(RPM)
(m/s)
5500 100
5500 100
4800 100
4800 100
Compatibility
with rail saw
type:
RDS-14P.78
RDS-14P
RDS-14P.78
RDS-14P