Table of Contents
Advertisement
3.3) Auxiliary switching device
STOP button (1)
(switches the rail saw off )
RESET button (2)
(stops the air fi lter cleaning alarm)
Protective rubber case
TECHNICAL DETAILS:
frequency:
433 Mhz
max. distance:
5 metres
power:
CR2032 Lithium cell battery
dimensions:
48x20xh107 mm
weight:
54 g
Item code:
6003788
The device supplied with the rail saw has 2 main functions:
- Switching off the machine: the main control for turning off the rail saw off is the
switch (18) on the machine itself. The machine can also be turned off with the auxiliary device
by simply moving towards it while pointing the device and pressing the STOP button
(1).
- Reset of the air fi lter cleaning alarm: after turning off the machine, when the alarm
has been triggered, point this device at the machine and press the yellow
RESET button (2) 3 times in succession in order to reset the alarm code. With each pulse
the machine will beep in recognition.
If the device is not able to control the machine:
– check there are no obstacles between the device and the machine.
– move much closer to the machine, it is likely that you are out of range.
– fully accelerate the machine for at least 10 seconds.
– replace the old battery (mod. CR2032) with a new one.
• Replacing the battery:
– Remove the rubber case by pulling it off from the aerial side.
– Press down on the rear compartment cover while sliding it in the direction of the arrow.
– Remove the dead battery and insert a new one, making sure it is the right way up.
– Replace the cover and the protective rubber case.
If it is expected that the device will not be used for a long time, it is advisable to remove the
battery in order to avoid damage caused by possible leaks and corrosion.
Batteries must be disposed of separately to other waste in accordance with local sta-
tutory requirements.
Aerial
Hook
Battery
compartment
Cover
REAR
VIEW
8
Advertisement
Table of Contents
