Table of Contents
Advertisement
3.2) Safety devices on the machine
The safety devices supplied on the RAIL SAW and listed below must be fully functional and
checked before each use. If this is not the case do not use the machine and contact Cembre
for any repairs.
- ON/OFF SWITCH (18) this is found in a very visible
position and is easily operated. It is used for stopping
the machine normally or in emergency.
Ensure you are familiar with how to use the switch
(18) so that you can act promptly in case of emergency.
- ACCELERATOR (20):
to full operating speed. It can only be activated by
pressing the interlock lever at the same time (21).
- INTERLOCK LEVER (21): prevents accidental
activation of the accelerator which cannot be activated
without pressing this lever.
When the accelerator is released, the abrasive cutting disc continues to turn for some
time. Do not approach the cutting group until the disc has completely stopped.
- ACCELERA TOR BLOCK (22):
•
it locks the accelerator in start-up position
•
it locks the accelerator in maximum acceleration position.
This function must only be used in automatic
mode with the AA-RDS automatic support arm.
The accelerator block (22) can only be
activated by pressing the accelerator (20)
and the interlock lever (21) at the same time.
Once activated, press the accelerator down.
- SAFETY GUARD (3)
which fl y off during cutting. Push the handle forwards or backwards to fi nd the most
eff ective position.
Never use the RAIL SAW
without the safety guard or when
the guard is damaged!
7
this is used to run the engine
has two functions:
designed to protect the operator from fragments and sparks
when the engine is
cold.
max.acceleration positions
18
22
20
start up and
3
21
Advertisement
Table of Contents
