Table of Contents
Advertisement
– Start the cut by using regular alter-
nate movements, maintaining a steady
pressure during the whole cutting phase.
The double articulation of the support arm
will relieve the operator of the weight of
the machine thus making the cutting
operation easier.
aggregate
– Once the operation is fi nished, release the accelerator, lift the
rail saw and re-lock the arm in its resting position by pushing
in the lever (7) fully .
– Switch off the engine by using the switch (18) and wait for the
disc to completely stop turning before carrying out any further
interventions.
NOTE: Some factors such as the diameter of the cutting disc, a partially worn disc and the rail
dimensions, can infl uence the cutting operation and prevent the execution of a full cut. In such
a case, the arm will have to be overturned (Ref. to § 8.3) and the process completed by taking
up the cut on the opposite side.
min. 15 cm
18
Taking up
procedure
28
Advertisement
Table of Contents
