Table of Contents
Advertisement
IMPORTANT (Ref. to fi gure below): Make sure that at the end of rotation, lever (L) is resting
on the bushes (A) so that the spring rod is positioned downwards; otherwise, it will not be
possible to support the rail saw and perform the cut.
1
11
3
The fi gure below shows the correct position of the transmission gear (8) on both sides of the rail
to be able to mount the rail saw in the correct manner; if it not is as represented in the fi gure,
repeat the above steps.
8
19
6.3.1) Rotating the interface group
The overturning of the arm from one side of the rail to
the other also requires the rotation of the interface group
2
(G) in order to bring the transmission gear (8) into the
correct position to allow the rail saw to be mounted.
1- Rotate the unlocking lever (11) and, keeping
it pulled, slowly rotate the interface group (G).
2
- Release the lever (11) and continue to rotate the
(G)
group (G).
3
- At full rotation, the lever (11) will go one step further
into a suitable slot. A distinctly audible "click" will
confirm that the operation has been performed
correctly.
NOTE: for practical reasons, we recommend the interface
unit is rotated before overturning, in any case it is important
CLICK
that at the end of rotation the transmis-
sion gear (8) is positioned at the low point.
8
L
A
8
Advertisement
Table of Contents
