Table of Contents
Advertisement
– With the disc in contact with the rail, completely release the arm.
– The rail saw will automatically perform regular alternate movements simulating the
cutting action of an operator.
During operation always keep a safe distance and always monitor the cutting process
in order to readily intervene in case of problems.
Never leave the rail saw unattended!
aggregate
– When the operation is complete, the rail saw will automatically turn off due to an electronic
system which detects the rpm variation of the engine.
– Unlock the accelerator from the maximum acceleration position by pressing it
right down.
– Lift the arm and put it back into stationary position, re-locking the blue lever (18).
NOTE: Some factors such as: diameter of the cutting disc, a partially worn disc and dimensions
of a full cut, can infl uence the cutting operation and prevent the execution of the rail cutting;
in such a case it will be necessary to overturn the arm (Ref. to § 6.3) and complete the operation
by taking up the cut on the opposite side.
min. 15 cm
Taking up
procedure
22
Advertisement
Table of Contents
