Mounting The Cutting Disc - Cembre RDS-20P Operation And Maintenance Manual

4.3) Mounting the cutting disc

WARNINGS:
– This operation must be performed with the engine switched off .
– Before using a cutting disc, always verify its compatibility with the rail saw
and observe the rules set out in § 3.4.
– Verify that the hub of the disc is perfectly suitable for the shaft.
– Always mount the disc complete with pressure plate.
– In order to avoid an overtightening of the screw (12), start the engine only when
the abrasive cutting disc is mounted.
– With the 13 mm multifunction spanner supplied, unscrew the locking screws (12) and
retrieve the pressure plate (S).
– Mount the disc on the shaft inside the safety guard so that
it rests on the central stop.
– Mount the pressure plate and lock
all the screws (12) tightening with
a 20-25 Nm.
During the tightening phase
counteract the movement.
of the disc with one hand.
11
min. 3 m (10ft)
S
20-25 Nm
non-spill fuel
container
1
2
12