Default Settings - Siemens FDOOT221 Technical Manual

4 Planning

Default settings

4.6 Default settings
64
Building Technologies
Fire Safety
The detector operates in the default parameter set as long as the control panel has
not assigned a valid parameter set to the detector.
The following table shows the default parameter set of the various fire detectors.
Fire detector
FDOOT241-x/-Ax in FDnet operation
FDOOT241-9 in collective operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT241-A9 in collective operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT241-A3 in AnalogPLUS mode:
As DO1131A
As DOT1131A
As DT1131A
As DT1132A
FDOOT241-A4 in SIGMALOOP mode:
In SIGMALOOP mode the sensor
evaluation takes place in the control panel
FDOOT241-8 in MS8 operation:
Sensor mode 0 (neural fire detector)
Sensor mode 1 (heat detector)
Sensor mode 2 (smoke detector)
FDOOT221
FDO241
FDO221
FDT241
FDT221
Upon commissioning of the fire detection system, the optimum parameter set must
be selected based on the existing risk and the ambient conditions.
If the fire detectors are operated on the FDnet (addressed), the fire detectors are
automatically set to the basic setting for the country in question when the control
panel is started up for the first time. Individual adaptation takes place using the
commissioning software on the corresponding control panel.
If the fire detectors are operated in collective, MS8, SIGMALOOP or AnalogPLUS
operation, the detectors operate with the default setting the first time they are
commissioned. In this operating mode, individual adaptation of the detector
behavior is performed using the detector exchanger and tester FDUD292.
Default parameter set
High Compensation
ES <13 = Insensitive
ES 13 = High Compensation
A1R
Universal
High Compensation
A1R
Universal
Sensitive
Fast Response
A1R
BS
Sensitive
A1R
Universal
Standard
Robust
Standard
A1R
A1R
007004_n_en_--
01.07.2012