Toshiba VF-S15 Instruction Manual page 63

3.2.1 How to run and stop
[Example of  setting procedure]
Panel operation LED display
MODE
cmod
0cmod
(1) Run and stop using the panel keypad (cmod=1)
RUN
Use the and
: Motor runs.
RUN
☆The direction of rotation is determined by the setting of parameter  (forward run, reverse run
selection). (: forward run, : reverse run)
☆Forward run and reverse run are switchable with the extension panel (option). Set the parameter fr
(forward run, reverse run selection) to 2 or 3. (Refer to section 5.8)
(2) RUN and STOP using external signals (cmod=0): Sink (Negative) logic
Use external signals to the inverter terminal block to start and stop the motor.
Short and terminals: run forward
F CC
Open and terminals: slow down and stop
F CC
Displays the output frequency (operation stopped).

(When standard monitor display selection f710=0 [output frequency])
Displays the first basic parameter [History (auh)].
auh
Turn the setting dial, and select "cmod".
Press the center of the setting dial to read the parameter value.
1
(Standard default: 1).
Turn the setting dial to change the parameter value to 0 (terminal block).
0
Press the center of the setting dial to save the changed parameter.
cmod and the parameter set value are displayed alternately.
STOP
keys on the panel keypad to start and stop the motor.
: Motor stops.
STOP
C-5
Operation
Frequency
F-CC
E6581611
Slow down
and stop
ON
OFF
3