Toshiba VF-S15 Instruction Manual page 119

7.2.2
This function is used to output a variety of
signals to external devices from the inverter.
With the logic output terminal function, you can
select from multiple output terminal functions.
Set two types of functions for the RY-RC, OUT
terminal and then you can output when either one
or both of them is ON.
Default settings of slide switch SW1and SW2 are
as follows;
SW1: PLC side, SW2: VIB side and S3 side.
Refer to page B-11 to 13 for details.
7
 Usage
Note1) A chattering (momentary ON/OFF of contact) is generated by external factors of the vibration and the impact,
etc. In particular, please set the filter of 10ms or more, or timer for measures when connecting it directly with
input unit terminal of programmable controller. Please use the OUT terminal as much as possible when the
programmable controller is connected.
Output terminal function (sink logic)
Function of FLA, B, C terminals:
Set at parameter Note 1)
Function of RY terminal:
Set at parameter  and 137 Note 1)
Function of OUT terminal:
Set at parameter   a nd 
[Control terminal block]
SW2
VIB
PTC
VIA VIB CC VIC
PP
NO OUT
CC P24
FLA
FLB
FLC
RY
RC
OUT
NO
G-6
E6581611
SW1
SINK SOURCE
S4
S3
PLC
S3 FM
FLA FLB FLC
+24
F R CC +SU
S1 S2
RES
FL
RY RC