1.3.2
Never touch the internal connector while the upper cover of control panel is opened.
Prohibited
1
When removing and mounting the terminal cover or the terminal block with a screwdriver, be sure not
Pressing too hard on the screwdriver may scratch the inverter.
Mandatory
Always turn the power off when removing the wiring cover.
action
After wiring is complete, be sure to replace the terminal cover.
Use the following procedure to open the terminal cover and pull the power terminal block.
Inverter type
VFS15-2004PM-W to 2007PM-W
VFS15S-2002PL-W to 2007PL-W
VFS15-2015PM-W to 2037PM-W
VFS15S-2015PL-W, 2022PL-W
VFS15-4004PL-W to 4015PL-W
VFS15-4022PL-W, 4037PL-W
VFS15-2055PM-W to 2150PM-W
VFS15-4055PL-W to 4150PL-W
Opening terminal cover and terminal block
There is a risk of electrical shock because it carries a high voltage.
to scratch your hand as these results in injury.
Procedure
In the beginning, remove the outside terminal
block cover.
Next, remove the inside terminal block cover.
In the beginning, remove the outside terminal
block cover.
Next, remove the inside terminal block cover.
In the beginning, remove the outside terminal
block cover.
Next, remove the inside terminal block cover.
Follow a procedure and remove the power
terminal cover.
Warning
Caution
A-6
E6581611
Reference
number
(1)
(2)
(3)
(4)
(3)
(5)
(6)