About module display
Module buttons are highlighted while a 16-step key of a step including
modulated parameters is pressed.
1 The following is an example of when step modulation is performed
for [PITCH] (in PLAYBACK) and [ATTACK] (in AMP ENVELOPE).
2 Press and hold a 16-step key of a step with a parameter modulated.
3 The module button is highlighted and the parameter name is
enclosed with a frame while the button is held down.
Track attribute switching button
This mode is for playing an audio sample or a sound source that has
been sampled. If no sound source is assigned to a track, [----] is dis-
played in the sample name field.
If the [BROWSE] or [SAMPLING/EDIT] button is pressed and a sample
is assigned in the screen of the switching destination, the sound source
becomes set for the track. If you wish to further adjust the sound source
itself, press the [SAMPLING/EDIT] button to switch to the EDIT screen.
Each of [PLAYBACK], [AMP ENVELOPE], [FX 1], and [SEQUENCE] is a
button, and a thumbnail is displayed in a small windows in the button in
accordance with values set in the screen of the switching destination.
An external input can be assigned to a track to apply an effect.
Adjust the [INPUT LEVEL] control on the rear panel of the unit and the
volume of the source device while looking at INPUT MONITOR. At that
time, if the [SOFT LIMIT] button (ON/OFF toggle operation) is pressed,
the limiter input at the input stage is enabled to reduce unnecessary
The track can be output by bypassing [AMP ENVELOPE] and [FX]. The
default is OFF.
Setting the track attribute
The track attribute can be set.
Tapping the [TRACK TYPE] button toggles between [SAMPLE] and
There are the following two types of TRACK TYPE.
Selecting and loading a sample sound
You can search for sound sources and assign them to tracks.