Connections And Part Names; Connections - Pioneer TORAIZ SP-16 Operating Instructions Manual

Connections and part names

Connections

Be sure to turn off the power and unplug the power cord from the power
outlet whenever making or changing connections.
Connect the power cord after all the connections between devices have
been completed.
Be sure to use the power cord, AC adapter, USB cable and LAN cable
included with this product.
Connecting the input/output terminals
 Rear panel
PRO DJ LINK compatible DJ system
1 2 3 4
1 Cord hook
Hook the AC adapters' power cord here.
! The sound will be interrupted if the AC adapter's power cord is
disconnected from the unit during playback.
Using the cord hook
Hook the AC adapter's power cord onto the cord hook to fasten it in
place. This prevents the power cord from being accidentally pulled, caus-
ing the plug to get disconnected from the terminal.
! The sound will be interrupted if the AC adapter's power cord is dis-
connected from the unit during playback.
1 As shown on the diagram below, extend the tip of the power cord to
approximately the center of the rear panel of this unit and hook the
power cord onto the bottom side of the cord hook.
External sequencer, etc.
5 6
Synthesizer, etc.
Refer to the operating instructions for the component to be connected.
! When using a LAN cable for connection, be sure to use either the
LAN cable included with this product or an STP (shielded twisted
pair) cable.
! Do not disconnect the LAN cable when information is being
shared using PRO DJ LINK.
Computer
Audio I/F
7 8
2 As shown on the diagram below, move the tip of the power cord back
in the opposite direction past the top of the cord hook, and hook the
power cord onto the top side of the cord hook.
3 Turn the tip of the power cord so that it is facing towards you, then
turn it back to create a ring as shown in the diagram and insert it into
the [DC IN] terminal of this unit.
Powered speakers
Headphones
9 a b
5
En