Connecting Power Cable And Usb Cable - Flashforge FINDER User Manual

4. After loading the PLA filament, adhere
the plate tape over the build plate, as
shown in the right picture.
Note: The plate can be dawn out from the
build platform.

Connecting power cable and USB cable

1. Insert the power supply into the
power input on the back of the
Finder and plug the power cord into
an electrical outlet.
2. Locate the USB cable and plug
one end into the Finder and the other
into your personal computer. The
Finder supports USB 2.0.
Finder User Guide| www.ff3dp.com