Build Plate; Power On - Flashforge Finder 3 User Manual

2.2 Build Plate

Finder 3 is installed with the glass platform by default, while users can also use the
flexible removable platform.
Glass platform: The bottom is flatter, but the removal of the model requires a scraper; If
the glass platform is used when the ambient temperature is low, it is recommended to
apply glue on it before printing to increase the adhesion.
Flexible removable platform: It adopts magnetic adsorption, thus the model can be
easily removed by removing the flexible steel plate and then bending it.
If you switch from the glass platform to the flexible removable platform
Note
plate, it is necessary to perform leveling and calibration.

2.3 Power On

Plug in the power cord and toggle the switch to turn on the power. Do not disconnect the
cables when Finder 3 is powered on.
3
2
1
Installation method of the flexible removable
platform plate:
1. Remove the glass platform.
2. Stick the magnet above the heating plate.
3. Then the flexible steel plate can be
absorbed on the magnet.
Attention
· Damage might occur if voltage setting
is incorrect. Make sure the current input
voltage matches to your local power
supply (115/230V).
· Plug in power cord and turn power
switch to 1 to turn it on.
08