Dsx-1-To-Dsx-1 Configuration - Paradyne HotWire 7924 User Manual

Worksheets

DSX-1-to-DSX-1 Configuration

A-2
To connect two DSX-1-compatible units, configure the units as follows. Terminal
mode factory defaults are in bold (for Switchpack mode defaults, see Appendix C,
Switchpacks and Jumpers
Configuration DSX-1-Compatible Unit
Option (Customer Premises)
Card Type CP (default)
Loops Enabled Dual (Loops A & B) or
Single (Loop A)
T1 Line Encode B8ZS or AMI
Framing D4, Extended Superframe,
or Unframed
Line Build-Out Enter 5 at the Config
command prompt. Select
from the following options:
1) 0 to 133 ft
2) 133 to 266 ft
3) 266 to 399 ft
4) 399 to 533 ft
5) 533 to 655 ft
October 1997
).
DSX-1-Compatible Unit
(Central Site)
CO
Must be same as CP side
Must be same as CP side
Must be same as CP side
Enter 5 at the Config command
prompt. Select from the following
options:
1) 0 to 133 ft
2) 133 to 266 ft
3) 266 to 399 ft
4) 399 to 533 ft
5) 533 to 655 ft
7924-A2-GB20-30