Making Changes From The Terminal Interface; Making Changes In Switchpack Mode - Paradyne HotWire 7924 User Manual

Customizing DSX-1-Compatible Units

Making Changes from the Terminal Interface

4-2
This guide depicts the system terminal menus as they appear from a CP unit.
This is the default configuration for Model 7924 standalone units.
The Board Configuration menu displays the current board software and hardware
settings. It also allows you to change certain parameters on the board.
This function is affected by the status of the switchpack (DIP switch control)
setting.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switchpacks and jumpers on the board hardware. Refer to

Making Changes in Switchpack Mode

To access the Board Configuration menu, enter 3 at the Main Menu Command
prompt.
Command 3
Board Configuration:
1) HDSL Card Type
HDSL Rate Type
2) Loops Enabled
3) T1 Line Encode
4) Framing
5) Line Build Out
HDSL FW Rev
AT+T FW Rev
CP Serial #
–––––––––––––––––––––––––––––––––––––––––––––––––––––––
1–5) Board Configuration
6) Switch pack Definitions
7) Line Build–Out Definitions
?) Redisplays this menu
Q) Quit
Config
Possible values for each parameter are listed in
Worksheets , for help in selecting the appropriate configuration options for your
application.
October 1997
on page 4-5.
– CP
– T1
– Dual Loop (Loops A and B)
– B8ZS
– D4
– 0 to 133 feet, 0dB
– 07
– 1.17
– 085561
Table 4-1. See Appendix A,
7924-A2-GB20-30