Connecting To The Network; Connecting Power To The Unit - Paradyne HotWire 7924 User Manual

Installing the Unit

Connecting to the Network

Connecting Power to the Unit

2-2
Procedure
1. Connect one end of the supplied 14 twisted-pair network cable into the rear
panel HDSL jack. Connect the other end to your HDSL network interface.
NOTE:
Do not use a flat VF network cable, as this may severely degrade the
performance of the termination unit. Use only a twisted-pair network
cable.
2. Connect a V.35 or DSX-1 interface cable into the appropriate connector on
the rear panel. Connect the other end to your V.35 or DSX-1 equipment.
HotWire 7924 V.35-compatible units are not designed to be used at both ends of
an HDSL connection.
HDSL
DSX-1-Compatible HotWire 7924 – Rear Panel
HDSL
V.35-Compatible HotWire 7924 – Rear Panel
Plug the power transformer into the appropriate (115 or 230 Vac) power outlet.
Connect the power lead into the – 48 Vdc jack on the rear panel.
To obtain information on the power supplies and power cord adapters available,
refer to Warranty, Sales, and Service Information
this User's Guide.
October 1997
48 VDC
V.35
48 VDC
on page A at the beginning of
DS1
97-15356-01
97-15264
7924-A2-GB20-30