Remote Unit Information - Paradyne HotWire 7924 User Manual

Remote Unit Information

7924-A2-GB20-30
The type of statistics displayed under the T1 Errors column depends on the type
of framing selected. When the unit is configured for D4 framing, FAS (Frame
Alignment Signal) errors are reported. When the unit is configured for ESF
framing, CRC (Cyclic Redundancy Check) errors are reported.
Glossary
Refer to the for definitions of the errors reported.
The same type of information provided for the locally attached unit can also be
displayed (but not changed) for the unit on the other side of the connection.
You can display information about the CO unit by using the HTUC menu options
from a terminal attached to the CP unit, and you can display information about
the CP unit by using the HTUR menu options from a terminal attached to the CO
unit.
To access the HTUC or HTUR menu, enter 7 at the Main Menu Command
prompt.
***** HTUC Menu *****
1) Board Status
2) Performance Monitor
3) Board Configuration
4) Line Build Out Configuration Help
?) Redisplays this Menu
Q) Quit
HTUC Command
October 1997
Monitoring the Unit
6-5