Displaying Line Build-Out Definitions - Paradyne HotWire 7924 User Manual

Customizing DSX-1-Compatible Units

Displaying Line Build-Out Definitions

4-6
Enter 7 at the Config prompt to display the switchpack and board settings for line
build-out. Use this information to change the line build-out parameter manually.
(Switchpack definitions are also listed in Appendix C,
Config 7
***** SWITCHPACK SETTINGS FOR LINE BUILD OUT
Switchpack Settings
–––––––––––––––––––––––––––––––––––
Position #4 – Bit 0
Position #5 – Bit 1
Position #6 – Bit 2
************ Switchpack Definitions ************
Bit 2 Bit 1 Bit 0 Application
–––––––––––––––––––––––––––––––––––––––––––––––
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
Config
For example, to change the line build-out to 399 to 533 feet, while in Switchpack
Mode, set position 6 OFF and positions 4 and 5 ON.
NOTE:
The switch combinations for –7.5, –15, and –22.5 dB line build-out are not for
use with this product. Use of these settings will cause a weak signal and
degrade performance.
October 1997
Switchpacks and Jumpers
OFF=0, ON=1
OFF=0, ON=1
OFF=0, ON=1
0 to 133 feet – 0dB
133 to 266 feet
266 to 399 feet
399 to 533 feet
533 to 655 feet
-7.5 dB
-15 dB
-22.5 dB
.)
*******
7924-A2-GB20-30