Paradyne HotWire 7924 User Manual page 26

Customizing V.35-Compatible Units
Making Changes from the Terminal Interface
5-2
The Board Configuration menu displays the current board software and hardware
settings. It also allows you to change certain parameters on the board.
This function is affected by the status of the switchpack (DIP switch control)
setting.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switchpacks and jumpers on the board hardware. Refer to
Making Changes in Switchpack Mode
To access the Board Configuration menu, enter 3 at the Main Menu Command
prompt.
Command 3
Board Configuration:
1) HDSL Card Type
HDSL Interface/Rate – V.35 T1
2) Loops Enabled
3) Payload Rate
Transmit Timing
HDSL FW Rev
AT+T FW Rev
CP Serial #
–––––––––––––––––––––––––––––––––––––––––––––
1–3) Board Configuration
4) Switch pack Definitions
?) Redisplays this menu
Q) Quit
Config
October 1997
on page 5-4.
– CP
– Dual Loop (Loops A and B)
– 1536 Kbps (24x64)
– Loop
– 03
– 1.17
– 85649
7924-A2-GB20-30