Exporting Programmable Scanning Data To The Receiver - Sony ICF-SC1PC Operating Instructions Manual

Note
You cannot exclude a band if it is the only target band.
To start scanning again manually during scan
pause
Click + or –.
Scanning will restart in ascending direction if you click +,
and in descending direction if you click –.
To change scanning direction during scanning
Click + or –.
Scanning will change to the ascending direction if you
click +, and to the descending direction if you click –.
To stop scanning
Click [SCAN STOP].
Scanning will stop at the present frequency.
Exporting Programmable Scanning
data to the receiver
You can export Programmable Scanning data on the
controller to the receiver. This will overwrite the present
Preset L and Preset U frequencies in the receiver.
Note that once the data is overwritten in the receiver, you
cannot retrieve the old data.
1
Select [Send Program Data To Receiver] from the
[Options] menu.
The Send Program Data To Receiver dialog will
appear.
2
Select the options to your choice and click [OK].
Type in the lower and upper limit frequencies.
Select a detection mode from the pull-down menu.
Select a frequency step from the pull-down menu.
3
Click [OK] in the export confirmation dialog.
18