Specifying A Camera's Cable Length; Specifying The Receiver Type - Sony CSP-5000E Service Manual

Configuring the System

Specifying a camera's cable length

Use the "CABLE COMPENSATION" setting to make
up for any signal loss over the cable line connecting a
camera.
1
From the main menu, select "INPUT
CONFIGURE" and then press the SET key.
INPUT CONFIGURE
→
SOURCE ID
CABLE COMPENSATION
RECEIVER TYPE
VD
P/T LIMIT
2
Select "CABLE COMPENSATION" and then
press the SET key.
CABLE COMPENSATION
CAM TYPE
→
1 N
2 N
3 N
4 N
5 N
6 N
7 N
8 N
3
Select a camera number. If necessary, press the
NEXT or PREVIOUS key to see other pages.
4
Use the cursor keys to cycle through the options:
N, S, M, L, and LL.
See the following section for description of the
options.
30(EN)
http://getMANUAL.com
5
Repeat the same procedure with other cameras.
When you are ready, press the SET key to accept
the changes.
Options and corresponding cable length
Option N S M L LL
Cable 0- 160- 400- 700- 900-
Length 160m 400m 700m 900m 1200m
(cable type: 5C-2V)

Specifying the receiver type

Use the "RECEIVER TYPE" setting to specify the
type of camera in use.
1
From the main menu, select "INPUT
CONFIGURE" and then press the SET key.
INPUT CONFIGURE
→
SOURCE ID
CABLE COMPENSATION
RECEIVER TYPE
VD
P/T LIMIT
2
Select "RECEIVER TYPE" and then press the
SET key.
RECEIVER TYPE
CAM TYPE
→
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
6 NONE
7 NONE
8 NONE
3
Select a camera number. If necessary, press the
NEXT or PREVIOUS key to see other pages.
4
Use the cursor keys to cycle through the options:
NONE, STANDARD, STANDARD (PP),
MULTIPLE, and TWIST PAIR.
See the following section for description of the
options.
5
Repeat the same procedure with other cameras.
When you are ready, press the SET key to accept
the changes.
Options for receiver type
NONE: No receiver
STANDARD: Pelco Coaxitron TM receiver
STANDARD (PP): Pelco Coaxitron TM receiver
(preset type)
MULTIPLE: Pelco Intercept TM dome camera
TWIST PAIR: Videmech receiver
31(EN)