Running Programmable Scanning - Sony ICF-SC1PC Operating Instructions Manual

Running Programmable Scanning

1
Click [Program] under SCAN MODE in the main
window.
2
Select one or more bands in the target display.
To include/exclude bands
Click the band number or the band title in the target
display. Click a target band to exclude it from the
scanning target. Click an excluded band to include it
in the target.
3
Adjust the SQL control on the receiver.
Adjustment of the SQL (squelch) control is essential to
all scanning procedures. Adjust it on the receiver (see
"Adjusting the SQL control" in the Operating
Instructions of the scanning receiver).
You cannot adjust the SQL control from the controller.
When scanning:
PROGRAMMABLE SCAN-RUN appears in the mode
display.
The current target band will be highlighted in the
scanning target display.
SCANNING will flash and the detection mode and
the frequency step will appear in the frequency
display.
The scanning indicator will display the progress of the
scanning within the band.
At scan pause:
The mode display changes to PROGRAMMABLE
SCAN-PAUSE.
The frequency display will show the frequency,
detection mode and the frequency step.
The receiver resumes scanning automatically when
the signal breaks off.
(For scan pause time options, see "Adjusting scan
pause time", page 44).
z
If the last performed mode of scanning was Programmable
Scanning, you can also run Programmable Scanning by clicking
[SCAN START] in the Manual Mode.
17