Introduction And Specifications; Overview Of Parameters And Specifications - Everlast PowerMTS 251Si Operator's Manual

Section 1
Overview of Parameters and Features*
MIG/TIG/Stick Amp Range
Volt Adjustment Range MIG
MIG Wire Feed Speed
Input Voltage
Welder Type
Wire Roll Size and Diameter
Pre/Post Flow Control MIG/TIG
Up/Down Slope of MIG Volts/ TIG Amps
Synergic MIG
MIG Burn Back Timer Control
Inductance/Arc Force Control
MIG/TIG Pulse Frequency
Base MIG Volts/Pulse TIG Amps
Pulse MIG/TIG Time On/Balance
Memory
MIG Spot and Stitch Timer
MIG Burn Back Timer
Stick Hot Start Timer
Stick Hot Start Intensity Control
Stick E6010 Capability
Power Cable Length
Accessories
*See next page for complete electrical and technical data.
**Specifications subject to change without notice.
Power i-MIG 251Si**
120V: MIG 30-150A/ TIG 10-150A/ Stick 10-120A
240V: MIG 30-250A/ TIG 10-250A/ Stick 10-200A
120V: 15.5-22V 240V: 15.5-30V
120V: 60-400 (5-10 m/min)
120-240V Single phase (208V permissible)
Digitally controlled, IGBT inverter type with CV Pulse MIG , Pulse TIG, CC Stick functions.
.023"-.062" wire diameters possible with optional drive rolls.
12" diameter roll (Up to 44 lbs.); 8" adapter available (10-12 lbs.); 4" Diameter NOT SUPPPORTED
MIG: (Pre) 0-10 Seconds/ (Post) 0-10 Seconds; TIG (Pre) 0-10 Seconds/ (Post) 0-10 Seconds
MIG: 0-1 Second; TIG: 0-10 Seconds
Synergic MIG function for wires from .023" to .045" in diameter, with mild steel, stainless and Alumi-
num settings. Synergic feature operates via speed control on MTS version of Spool gun as well.
0-2 seconds
0-100%
MIG: 10-250 Hz; TIG: .5-500Hz
MIG: 10-100% of Peak Volts; TIG: 3-95% of Peak Amps
MIG 10-90%; TIG 5-95%
Saves up to 9 programs.
0-15 Seconds
0-2 Seconds
0-2 Seconds
0-100% over set amperage
Not recommended, however E6011 may provide a more stable arc.
9.5 ft. (3m)
24 Series MIG torch ( some units, 25 Series) torch 9.5 ft. (3m), Work clamp with cable 9.5 ft. (3m)
300 A Stick Torch with cable (3m), Floating ball type regulator.
9

Introduction and Specifications

240V: 60 to 600 IPM (.5-15 m/min)