Everlast PowerMTS 251Si Operator's Manual page 25

Section 2 Setup Guide and Component Identification
the toes of the weld, or burn though may occur.
In Pulse MIG mode, the MIG Volts will not be se-
lectable and will default to MIG Pulse Volts when
the Voltage is selected. Voltage is not adjustable
in TIG or Stick mode. In these processes, Voltage
is controlled by arc length. Heat generated by
voltage in stick mode can be managed through
consistent feeding of the rod into the puddle to
control the arc length.
7. PULSE MIG and TIG Features. See individual sec-
tions on pulse found later in this manual.
25