Connections And Configuration; Cerebrum Module Connections Panel - Martin maxxyz modules series User Manual

4. Connections and configuration

4.1 Cerebrum Module connections panel

RESET Use a ballpoint pen or pencil to press this switch. Activating the
switch causes a hardware reset.
POWER ON Use a ballpoint pen or pencil to press this switch. Activating the
switch is needed if the module refuses to start when power is
applied to the module and the Power Switch is set to ON
EtherDMX Artnet-compatible network XLR
USB USB device socket
External VGA External monitor connector
DMX A, DMX B DMX outputs (RDM-ready)
WING OUT 1, Wing output RJ45 in XLR-type housing. Important! Connect only
WING OUT 2 other non-controller modules (Programmer, Submaster,
Playback or Button Modules) to these outputs. Never use this
output to connect to a Maxxyz, Maxxyz Compact, Maxxyz PC
or another Cerebrum module.
MIC Audio microphone input
Line input Stereo line-level audio inputs, left and right
Line output Stereo line-level audio outputs, left and right
REMOTE MaxNet controller network RJ45 in XLR-type housing
NETWORK
Maxxyz Modules User Manual 14