Operation Of Remote Control; Timer Button - mundoclima MUCO-H6T Owners And Installation Manual

Operation of remote control

NOTE: This Remote control is universal, it c o uld be used formany units, some buttons
of this control which are not availabl e to this unit will not be described below.
Remote control
HEALTH SAVE
HEALTH SAVE
HEALTH function:there is no this function
●
for this unit. If press this key, the main unit
will click, but it also runs under original status.
Save energy function: this unit has no this
●
function, press this button, the mian unit will
click, "SE" will be displayed on the LCD of
wireless remote control, fan speed automatically
rotates, when repress this button, the fan speed
will run at previous setting fan speed.
TURBO
Turbo button
Set turbo on or off(the characters of turbo
●
will appear or disappear ) by pressing this
key unde r cooling or heating mode.Once
energized, the unit will be defaulted to be
turbo off. This function can not be set under
auto, dehumidify or fan mode, and characters
of turbo won't appea r .
Names and functions of remote control buttons
FAN
AUTO
HEALTH
AIR X-FAN
HUMIDITY
FILTER
TURBO
HOUR
ON/OFF
ON/OFF
MODE
FAN
X-FAN TEMP
TIMER
TURBO SLEEP LIGHT
button
TIMER
On the status of the unit on, press this
●
button to set timer off. On the status of
the unit off, press this button to set timer
off. Press this key once, words Hour on(off)
will appear and flicker. In which case, press
+/- button to adjust time (press+/- button
continuously to change timing value quickly
the setting time range is from 0.5 to 24 hr. ;
press this key once again to fix the time,
then remote controller will send out the signal
immediately and hour on/off will stop flickering.
If the time of that no press timer button
under flickering status is above 5s,the timer
setting will quit. If the timer has been set,
press this button once again to quit it.
TEMP
Temp. display button
After powered on, displaying presetting
●
temperature is defaulted,(According to
customer requirements to display,if there
are no requirements,the presetting temp-
erature displaying is defaulted, there is
no signal display on the remote control).
Press this button, (display
the presetting temperature; (display
display indoor ambient temperature,
(display ), display ambient temperature,
If current display status is indoor ambient temp.
when received other remote control sginal,
then will display presetting temp., 5s later
return to ambient temp. display.
Other models haven't this function. But
pressing this button, the main unit will click
and keep the original status.
13

Timer button

), display
),