Settling The Bobbin - HIGHLEAD HLK-1510 Instruction Manual

(5) Pass through the thread from the thread
○
stand 4 as shown on the right figure .
then ， wind the thread to the empty
○
bobbin 5 in the arrow mark "a"
direction couple times and insert the
○
bobbin 5 into the bobbin winder
(6) Push the adjust lever
"b" direction．
(7) Step on the gray color start foot switch
． The thread is kept winding to the
○
Bobbin 5 while the gray color start
switch is stepping on．
(8) When the bobbin becomes full of the
thread，the adjust lever
the original position．
(9) Step the gray foot switch to exit winding mode, and press the Escape key
operation interface．
(10) To wind the bobbin thread during the sewing operation，carry out above (2) to (7) procedure，then，the
bobbin winding is performed automatically．

5-4 Settling the bobbin

○
(1) Set the bobbin 2 into the bobbin case
(2) Pull the bobbin thread
thread through the thread hole
(3) At this time，pull the bobbin thread
○
the bobbin 2 if it is rotaled to the arrow direction． if it is
not，set the bobbin
to get the proper rotation.
From the library of: Superior Sewing Machine & Supply LLC
○
6 ．
○
7 in the arrow mark
○ 8
○
6 is returned to
○
1 ．
○ ○
3 into the slit 4 and pass the
○
．
5
○
3 then，check with
○ ○
2 into the bobbin case 1 over again
—
9
—
to back to the standard