HIGHLEAD HLK-1510 Instruction Manual page 22

[NOTE]If the thickness of the sewing material changes very often，it is recommended to takethe easy
way for the adjustment of the presser foot position with the method thatchange only the fixed
position of the presser foot after fixed the presser foot bar at higher position． For this
adjustment，loosen the setscrew
7.6.2 Adjustment of the presser foot lift during the sewing
[NOTE]The presser foot lift during the sewing can be adjusted 0 and 2～10mm．
(1) The presser foot lift during the sewing becomes 4～10mm at the condition which the connection of the
○
link 2 and the lever
if the connection is made with A hole，and it becomes 0 mm if the connection is made with B hole．
(2) The stepping lift is adjusted 4mm when the sewing machine is shipped from the factory．
(3) For the adjustment at the each range of the presser foot lift，remove the link cover
move the adjust bolt
○
(4) If the link 2 connection is changed to A or B hole， the presser foot position is also changed． So reset the
presser foot position with adjusting the position of the presser foot bar or the presser foot itself with
loosing their setscrews
(5) Regarding the running noise and the vibration， the higher lift effects worse． So adjust the presser foot lift
during the sewing as small as possible．
(6) After the adjustment，put the link cover
From the library of: Superior Sewing Machine & Supply LLC
○
16 then，move the presser foot
○
3 with the shoulder screw
○
5 ．
○ ○
．
6 or 7
○
4 and the face plate
17
—
○
○
1 is as shown on the figure and it becomes 2 to 4 mm
○
8 back on the original location．
—
12 up and down．
○
4 then，loosen and