3-4 Installation of the sewing machine head
Caution
★ For the safety,please make sure to carry the
sewing machine head by more than two
people.
(1) Make sure to hold the machine table
with the caster stopper.
(2) Fit the rubber cushion pads
○
4 on the tabletop . The
each hole
rubber cushion pads are enclosed in the
accessory box.
(3) Put the sewing machine head on the
table top and set the each leg
each rubber cushion pad
(4) Attach two hinges
machine bed .
(5) At this time, take notice that the E-shaped snap ring on the front side hinge must be come to the backside,
and E-shaped snap ring on the backside hinge must be come to the front.
(6) These parts are all enclosed in the accessory box.
(7) Fit the screw holes
through these holes and fasten the bolt
○
washers
12 and the nuts
(8) Fasten firmly hexagonal socket head set screws
○
hinges
6
perfectly.
(9) Insert the headrest
3-5 Installation of the spindle motor
If the spindle motor has been removed from
the machine for the adjustment or the like,
fix the spindle motor as the procedure
described right.
(1) Spindle motor according to right: put
the signal cord upward.
(2) Adjust the plane of the motor shaft
alignment of the left on the motor
mounting holes, 45 ° Angle adjustment.
From the library of: Superior Sewing Machine & Supply LLC
○
3 into the
○ 5 to the
○ 3
○
6 temporarily,make the setting screw
○
○
9 of the hinges
6 to the bolt setting holes
○
10 to fix the hinges
○
.
13
○
○
14 into the hole
15 on the tabletop.
—
○
7 fastening on the left side surface of the
○
8 ong the table top then, pass the bolt
○
6 with the flat washers
○
7 ,which set the hinges
4
—
○
11 ,the spring
○
6 temporarily then,fix the
○
10