Winding The Bobbin Thread; Settling The Bobbin - HIGHLEAD HLK-3020 Instruction Manual Parts Catalog

5-3 Winding the bobbin thread

★Please make sure to pull the upper thread out of the needle before winding the bobbin thread
(1) Turn the power switch ON．
(2) Pass through the thread from the thread stand①as shown on the right figure . then，wind the thread
to the empty bobbin②in the arrow mark "a" direction couple times and insert the bobbin②into the
bobbin winder③．
(3) Push the adjust lever④in the arrow mark "b" direction．
(4) Step on the gray color start foot switch⑤．The thread is kept winding to the Bobbin②while the gray
color start switch is stepping on．
(5) When the bobbin becomes full of the thread，the adjust lever③is returned to the original position．
(6) Step the gray foot switch to exit winding mode. .
(7) To wind the bobbin thread during the sewing operation，carry out above (2) to (7) procedure，then，
the bobbin winding is performed automatically．
For the details ,please refer to the instructions on the technical manual [Operation Panel].

5-4 Settling the bobbin

(1) Set the bobbin②into the bobbin case①．
(2) Pull the bobbin thread③into the slit④and pass the
thread through the thread hole⑤．
(3) At this time，pull the bobbin thread③then，check with
the bobbin②if it is rotaled to the arrow direction．if it
is not，set the bobbin②into the bobbin case①over
again to get the proper rotation.
— —
9