5-3 Winding the bobbin thread
★Please make sure to pull the upper thread out of the needle before winding the bobbin thread.
(1) Pass through the thread from the thread
○
stand
4 as shown on the right figure .
then, wind the thread to the empty bobbin
○
5 in the arrow mark "a" direction couple
times and insert the bobbin
bobbin winder
(2) Push the adjust lever
"b" direction.
※Caution: Bobbin winder does not work immediately after Turning ON the power. Perform the bobbin
winding after setting pattern NO. or the like once, pressing the
LED light up.
(1) Press
key to make the Sewing LED go off.
(2) Select the bobbin winder
key. The work clamp feet ⑨come down and the Sewing LED lights up.
(3) Press
(4) When the pedal ⑧is depressed, the sewing machine rotates.
(5) When the pedal ⑧is depressed again, or
(6) When
key is pressed, the Sewing LED goes off, the work clamp feet go up and
effective.
5-4 Settling the bobbin
(1) Set the bobbin
(2) Pull the bobbin thread
thread through the thread hole
(3) At this time,pull the bobbin thread
○
the bobbin
2 if it is rotaled to the arrow direction. if it is
not,set the bobbin
to get the proper rotation.
○
5 into the
○
6 .
○
7 in the arrow mark
with
○
2 into the bobbin case
○
3 into the slit
○
5 .
○
○
2 into the bobbin case
key.
key or
key is pressed, the sewing machine stops.
○
1 .
○
4 and pass the
3 then,check with
○
1 over again
10
key, and making the Sewing
key become