Table of Contents
Advertisement
OPERATION
1.Attaching the needle(Fig.7)
１）For needle, use "Mt×190"
２）Determine the needle gauge for thickness lf thread used.
３）Loosen the needle clamp screw.
４） Hold the needle with the prime groove turned to the front and
put it into the needle socket until it stops.
５）Tighten the needle clamp screw.
2.Winding the bobbin thread(Fig.8)
3.Threading the machine(Fig.9)
The needle should be threaded in the order numbered in the
right figure.
4.Setting of bobbin (Fig.10)
１）Raise flap 1 and remove the empty bobbin.
２）Insert bobbin 2 in such a way that when the thread is
unwound from it moves in the opposite direction to the
gripper.
３）Pass the thread through slit 5 and below spring 6, pass
the thread through slit 3 and pull about 3 cm through.
４）Close flap 1 and pass the thread through the flap's guide 4.
5.Leading out the bobbin thread(Fig. 11)
Pick up the end of needle thread by left hand and lightly press down the pedal by toe to run the machine one
turn. When the needle thread is pulled up, the bobbin thread will be drawn out as shown in the right figure.
6.Thread tension (Fig.12)
— 3 —
Advertisement
Table of Contents
