Precautions Operation; Installing Needle; Winding Bobbin Thread - HIGHLEAD GC24698-BRHL Instruction Manual

Note:Filling the oil to the hook saddle everyday during operation.
See dripping of oil through the oil window to check oiling condition during operation.

4. PRECAUTIONS OPERATION

（1）When the power is turned on or off, keep foot away from the pedal.
（2）It should be noted that the brake may not work when the power is interrupted or power
failure occurs during sewing machine operation.
（3） Since dust in the control box might cause malfunction or control troubles, be sure to keep the
control box cover close during operation.

5. INSTALLING NEEDLE

Note: Before installing the needle, be sure to turn off the power.
To install the needle, turn the machine pulley over toward operator(or
counter-clockwise) until the needle bar moves up to its highest point,
put the needle up into the needle bar as deeply as it will go, with the
long groove of the needle faced left side.Tighten the needle set screw
securely.
6. WINDING BOBBIN THREAD(Fig.5)
Note:When bobbin thread is wound, keep the presser foot lifted
Thread tension ： Particularly in the case of nylon or polyester
thread,wind the bobbin loosely.
（1）Press the bobbin onto the thread winding shaft.
（2）Pass the thread for winding thread as shown in the figure,
and wind the end of the thread clockwise around the bobbin several
times, then wind the thread on the thread adjuster side counter-clock
wise several times.
— 2 —