Open Existing Batch; Review Batches - Elcometer 456 Operating Instructions Manual

R
are removed from the list so that batch numbers
above 999 are valid. A deleted batch number
cannot be reused until all the batches are deleted,
when the batch number count starts again at 1.

7.3 OPEN EXISTING BATCH

This allows any batch to be opened to add readings.
If the gauge is switched off with the batch open, the
current batch will re-open when the gauge is
switched back on.
Note: If the probe is changed to another probe of
the same type the gauge will display a warning
(Figure 51).
Figure 51. Changed probe warning screen
If NO is selected, the serial number and calibration
data of the new probe are saved into the current
batch as a data entry.
38
If YES is selected, the batch calibration details are
retained and the user can locate and fit the original
probe, if they wish.

7.4 REVIEW BATCHES

This allows the content of any batch to be displayed
(Figure 52).
Status
area
Figure 52. REVIEW BATCHES screen
The Up/Down softkeys move the cursor through
the list of readings.
The Status softkey toggles the status area
on/off.
The Review Batches screen can contain the
following information:
• Readings (including
whether they are above or below limits if
LIMITS ON is activated).
symbols indicating